MIL-P-47099 Polyurethane Foam, Polyether Type, Rigid, For Packaging And Encapsulation Of Electrical ComponentsThis specification covers the requirements and tests for three types of two-component polyether type polyurethane foam,rigid, for packaging and encapsulation of electronic components.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12

MIL-P-47099A

2.2  Non-Government publications.  The following documents form a part of this document to the extent specified herein.  Unless otherwise specified, the issues of the documents which are DOD adopted are those listed in the issue of the DODISS cited in the solicitation.  Unless otherwise specified, the issues of documents not listed in the DODISS are the issues of the documents cited in the solicitation (see 6.2).

AMERICAN SOCIETY FOR TESTING AND MATERIALS (ASTM) ASTM D149        -              Dielectric Breakdown Voltage and

DielectricStrength of Solid Electrical

Insulating Materials at Commercial Power

Frequencies, Standard Test Method for

ASTM D150        -              A-C Loss Characteristics and Permittivity (Dielectric Constant) of Solid Electrical InsulatingMaterials, Standard Test Method for

ASTM D732        -              Shear Strength of Plastics by Punch Tool, StandardTest Method for

ASTM D1621      -              Compressive Properties of Rigid Cellular

Plastics, Standard Test Method for ASTM D1622      -              Apparent Density of Rigid Cellular Plastics, Standard Test Method for

ASTM D1623      -              Tensile and Tensile Adhesion Properties of Rigid Cellular Plastics, Standard Test Method for

(Application for copies should be addressed to the American Society for

Testing and Materials, 1916 Race Street, Philadelphia, PA  19103.)

(Non-government standards and publications are normally available from the organizations that prepare or distribute the documents.  These documents also may be available in or through libraries or other informational services.)

2.3  Order of precedence.  In the event of a conflict between the text of this document and the references cited herein, the text of this document takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.

3.  REQUIREMENTS

3.1  First article.  When specified (see 6.2), a sample shall be subjected to first article inspection (see 6.3) in accordance with 4.4.

3